EEG7000 Enhanced Electronic Governor
With J1939 TSC1 Capability
|
|
|
- Mini – ECUTSC1 Control Capable with Diagnostic Messages (DM)
- Isochronous, Variable or Customizable Droop Governor
- 3 Fixed Speeds or Variable Speed with Direct 0-5V, 5kὩ, or 4-20mA Input
- Built-in USB Port for Easy Configuration with Free Software
- Engine Hour Meter and Service Timer
- Built-in Speed Switch Output for Crank or Overspeed
- Black Smoke Reduction, Speed Ramp Control, Load Sharing / Synchronizing Option and Cummins EFC Capable
- Fully Sealed, IP67
The EEG7000 Enhanced Electronic Governor is designed to precisely control engine speed and provide fast, precise response to transient engine loads for diesel and gaseous fueled engines. When paired with a GAC actuator the EEG is a significant upgrade for any mechanical governor system that needs flexibility, precision or accurate speed control. The EEG is designed for industrial engine applications from generator sets, mechanical drives, pumps compressors, and off-road mobile equipment. The EEG7000 is programmed using GAC’s Interface Tool, consolidating the most popular features into one user-friendly, compact package. It can be controlled directly over J1939 with aftermarket displays such as ComAp, Dynagen, Murphy, etc.; a solution for every application.
|
|
|
|
|
|
Application of the Month:
ADC100 Pump Mounted Actuator
For All Stanadyne “D” Series Rotary Pumps
The EEG7000 controller is designed to work with proportional actuators and is proven to be very popular with the ADC100 actuator. Its compact design mounts directly onto all Stanadyne “D” series rotary pumps providing fast response and precise engine speed control for either isochronous, droop or variable speed operation. The ADC100 is approved by major OEM’s: FPT/Iveco, Aggreko, etc.… and is a direct replacement for Barber Colman and Woodward DYNC 70025 & DC 70025 series actuators but with better load acceptance / load rejection performance.
GAC has all the related hardware needed for fast easy installation of both the EEG7000 controller and ADC100 actuator: |
|
|
| Note: The DYNA 70025 actuator was originally manufactured by the Barber Colman Governor Company. Part numbers for both Woodward and Barber Colman are listed in the table. |
|
|
FAQ of the Month:
How do I wire an ESD5XXX Series governor for speed control with an external potentiometer?
A single remote speed adjustment potentiometer can be used to adjust the engine speed continuously over a specific speed range. Select the desired speed range and corresponding potentiometer value. (Refer to TABLE 1 below) If the exact range cannot be found, select the next higher range potentiometer.
To maintain engine stability at the minimum speed setting, a small amount of droop can be added using the DROOP adjustment. At the maximum speed setting the governor performance will be near isochronous, regardless of the droop adjustment setting. An additional fixed resistor may be placed across the potentiometer to obtain the exact desired range. Connect the speed range potentiometer as shown to Terminals G and J. Contact GAC for assistance if difficulty is experienced in obtaining the desired variable speed governing performance. |
|
|
|
|
|
新浪微博 |
官方微信 |
分享